Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1999A8 QUATTROREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 72 (ON BOARD DIAGNOSTIC (OBD) - RADIO, NAVIGATION, STEERING & TELEMATICS)NAVIGATION SYSTEM III (NS-LOW) THROUGH M.Y. 2001, ON BOARD DIAGNOSTIC (OBD)CONTROL MODULE VERSIONS, CHECKING (FUNCTION 01)
1999 Audi A8 Quattro
Control Module Versions, checking (function 01)
1999 Audi A8 QuattroSECTION Control Module Versions, checking (function 01)
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
Indicated on display
Fig 1: VAG1551 Scan Tool Display - Control Module Versions - Navigation System III, Through M.Y. 2001 (1 Of 3)
- Press buttons -0- and -1- to select "Check control module versions" function 01.
Indicated on display
Fig 2: VAG1551 Scan Tool Display - Control Module Versions - Navigation System III, Through M.Y. 2001 (2 Of 3)
- Press -Q- button to confirm input.
Indicated on display after approx. 5 seconds:
Fig 3: VAG1551 Scan Tool Display - Control Module Versions - Navigation System III, Through M.Y. 2001 (3 Of 3)
- 4B0919887A: Part number of control module for navigation (see also parts program)
- Navigation: component marking
- 0001: Software version of control module for navigation with CD drive
- Coding 00000: Coding not used
- WSC XXXXX: Dealership number
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.