Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
After replacement of entire steering system or steering gear
- Check hydraulic fluid level and top off, if necessary.
- Raise vehicle enough that front wheels turn without resistance.
- Start engine briefly (max. 2 s).
Steering wheel must not be turned, pump must not draw in air.
Waiting time between individual engine starts approx. 30 seconds.
- Check hydraulic fluid level and top off, if necessary.
- Keep repeating this procedure until fluid level remains constant.
- Turn steering wheel 10 times from end position to end position.
- Check hydraulic fluid level and top off, if necessary.
- Start engine.
- Turn steering wheel 10 times from end position to end position.
- Check hydraulic fluid level and top off, if necessary.
Residual air trapped in the steering system will dissipate on its own during driving operation after approx. 10 to 20 km.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.