Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Cable routing, front right
1999 Audi A6 BaseSECTION Cable routing, front right
NOTE:
The following list refers to Fig 1
.
- Main wiring set
- Cable to belt buckle (if installed)
- End switch-bottom
- On seat frame-inside
- Cable ties
- Harness connector for backrest motor and heater (seat/backrest)
- Harness connector to lumbar support motor
- Harness connector between seat- and backrest heater.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.