Special Tools & Equipment

1999 Audi A4 Base, 1.8 B, AutomaticSECTION Special Tools & Equipment
  • VW382/10 extension pin
  • VW385/1 measuring bar
  • VW385/2 centering disc
  • VW385/3 plastic piece
  • VW385/14 measuring rod
  • VW385/15 extension pin
  • VW385/17 magnetic plate
  • VW385/30 master gauge-adjustable
  • VW385/33 end gauge
  • VW387 dial gauge holder
  • VW388 measuring lever
  • VW401 thrust plate
  • VW402 thrust plate
  • VW408A punch
  • VW457 support channels
  • VW521/4 locking sleeve for ring gear
  • VW521/8 bushing for ring gear
  • VW540 holding fixture
  • 30-205 thrust pad
  • 2003/3 seal installer
  • 2052/2 assembly tool for drive pinion
  • 3005 thrust pad
  • 3028 retainer
  • 3062 thrust pad
  • 3253 wheel bearing assembly set with 3253/3 and 3253/4
  • 3304 retainer
  • Engine/transmission jack VAG1383A engine/gearbox jack
  • Dial gauge extension 30 mm
  • Dial gage
  • Torque gauge 0-600 Ncm

    See Fig 1-Fig 5 .

    Fig 1: Identifying Drive Pinion Adjusting Special Tools (1 Of 5)
    G00391946Courtesy of AUDI OF AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.