Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1999A4 BASE, 1.8 B, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)STEERINGPOWER STEERINGSTEERING SYSTEM - POWERREMOVAL & INSTALLATIONPOWER STEERING PUMPREMOVAL & INSTALLATION (2.8L ENGINE CODE AFC, AHA & ATQ)
1999 Audi A4 Base, 1.8 B, Automatic
Removal & Installation (2.8L Engine Code AFC, AHA & ATQ)
1999 Audi A4 Base, 1.8 B, AutomaticSECTION Removal & Installation (2.8L Engine Code AFC, AHA & ATQ)
- Unclip, and remove engine cover. Unbolt, and remove cover for drive belt. Loosen and remove drive belt. See Figure .
- Counter-hold belt pulley (5), using VAG1590 (if applicable) and remove. See Fig 1 . Mark position, and disconnect ignition wires from ignition coils. See Fig 2 .
- Pinch of suction hose using 3094 hose clamp. See Figure . Remove pressure and suction lines. Unbolt power steering pump bracket and remove together with pump. Remove bolts mounting pump to bracket and remove pump. See Fig 1 .
- To install, reverse removal procedure.
CAUTION:
Ignition wires must be installed in correct firing order. See Fig 2
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.