Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1998A8 SEDAN (4D2) V8-3.7L (AEW)REPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLETRANSMISSION SPEED SENSORSERVICE AND REPAIRTRANSMISSION VEHICLE SPEED SENSOR (VSS) -G38
1998 Audi A8 Sedan (4D2) V8-3.7L (AEW)
Transmission Vehicle Speed Sensor (VSS) -G38
1998 Audi A8 Sedan (4D2) V8-3.7L (AEW)SECTION Transmission Vehicle Speed Sensor (VSS) -G38
Note: Do not use sensor that has been dropped (the permanent magnet will break if it is dropped).
Removing
^ Remove oil pan, refer to Flid Pan, A/T, Service and Repair.
^ Remove transmission VSS -2-.
Installing
^ Install transmission VSS -2-, together with spacer sleeve -1- (height: 8 mm).
^ Change or top off ATF after repair.
Tightening torques
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.