Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1998A8 SEDAN (4D2) V8-3.7L (AEW)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSAUTOMATIC TRANSMISSION/TRANSAXLETORQUE CONVERTER
1998 Audi A8 Sedan (4D2) V8-3.7L (AEW)
Torque Converter
1998 Audi A8 Sedan (4D2) V8-3.7L (AEW)SECTION Torque Converter
Installation dimension
If the torque converter is correctly inserted, the distance between the faces of the threaded hole at the torque converter and the contact surface of the torque converter bell housing is approximately 23 mm (0.91 inch).
If the torque converter is not fully inserted, this distance is approximately 11 mm (0.43 inch).
CAUTION! If the torque converter is not inserted correctly, the driver of the ATF pump will be damaged when the transmission is attached to the engine.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.