SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1998A8 SEDAN (4D2) V8-3.7L (AEW)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTTRANSMISSION CONTROL SYSTEMSRELAYS AND MODULES - TRANSMISSION AND DRIVETRAINRELAYS AND MODULES - A/TCONTROL MODULESERVICE AND REPAIR5 SPEED AUTOMATIC 01V FWD
1998 Audi A8 Sedan (4D2) V8-3.7L (AEW)

5 Speed Automatic 01V FWD

1998 Audi A8 Sedan (4D2) V8-3.7L (AEW)SECTION 5 Speed Automatic 01V FWD



Removing And Installing TCM -J217-


Removing

- Switch ignition off.







- Open E-box in right side of plenum by unscrewing 7 bolts (arrows).
- Unclip bolt cover to unscrew bolt in upper right-hand section of illustration.







- Release multi-pin connector lock -2-, then disconnect multi-pin connector from TCM.
- Unscrew bolts (arrows) and remove TCM from E-box.
- Check container for water penetration and reseal if necessary.

Installing

- Install in reverse order of removal.
- Check DTC memory of TCM.

Disconnecting multi-pin connector from TCM -J217-







- Switch ignition off and wait approx. 30 sec.
- Push lock in direction of arrow to unlatch connector.
- Disconnect multi-pin connector from top.
- Install in reverse order of removal.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.