SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1998A8 SEDAN (4D2) V8-3.7L (AEW)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSSENSORS AND SWITCHES - COMPUTERS AND CONTROL SYSTEMSTRANSMISSION POSITION SENSOR/SWITCHSERVICE AND REPAIRMULTI-FUNCTION TRANSMISSION RANGE (TR) SWITCH, REPLACING
1998 Audi A8 Sedan (4D2) V8-3.7L (AEW)

Multi-Function Transmission Range (TR) Switch, Replacing

1998 Audi A8 Sedan (4D2) V8-3.7L (AEW)SECTION Multi-Function Transmission Range (TR) Switch, Replacing

Multi-function Transmission Range (TR) switch -F125-
Removing
^ Remove left transmission support.
^ Disconnect multi-function TR switch -F125- from transmission and pull off of selector shaft.

Installing





^ Locate multi-function TR switch on selector shaft.
Flat section on gearing in switch -3- must come to rest on flat section of selector shaft -1 -

Note: Locate the multi-function TR switch -F125- on the center of the selector shaft. Do not tilt the switch or push it on forcefully. Otherwise the switch contacts may be damaged.





^ Rotate switch until fitting hole -4- on switch housing can be located on fitting pin -2- on transmission housing.




Tightening torques




RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.