Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1998A8 SEDAN (4D2) V8-3.7L (AEW)REPAIR AND DIAGNOSISLIGHTING AND HORNSHEADLAMPHEADLAMP ALIGNMENT SENSORSERVICE AND REPAIRLEFT FRONT LEVEL CONTROL SYSTEM SENSOR -G78
1998 Audi A8 Sedan (4D2) V8-3.7L (AEW)
Left Front Level Control System Sensor -G78
1998 Audi A8 Sedan (4D2) V8-3.7L (AEW)SECTION Left Front Level Control System Sensor -G78
Left Front Level Control System Sensor -G78-, Removing and Installing
Removing
- The front level control system sensor -1- is bolted to a retaining plate on the long member with two socket head bolts -5- (5 mm).
- Disconnect connector.
- To remove sensor from retaining plate and linkage, remove hex nut -3- and both socket head bolts -2- (3 mm) at level sensor.
- Open clip -1- at control arm by lightly pressing together the catches. Then remove linkage -2-.
Installing
- Install in reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.