Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1998A8 SEDAN (4D2) V8-3.7L (AEW)REPAIR AND DIAGNOSISLIGHTING AND HORNSHEADLAMPHEADLAMP ALIGNMENT CONTROL MODULESERVICE AND REPAIR
1998 Audi A8 Sedan (4D2) V8-3.7L (AEW)
Headlamp Alignment Control Module: Service and Repair
1998 Audi A8 Sedan (4D2) V8-3.7L (AEW)SECTION Service and Repair
Removing:
See Remove trim of right B-pillar. Service and Repair
- The control module -1- is mounted under the trim for the right B-pillar.
- Disconnect electrical connector.
- Remove both bolts -2-.
Installing:
- Install in reverse order of installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.