Rear

1998 Audi A8 Sedan (4D2) V8-3.7L (AEW)SECTION Rear






Legend

NOTE: All Wheel Drive (Quattro) shown, Front Wheel Drive (FWD) models similar.

1 Spring Retainer, Lower
2 Rear Coil Spring
3 Spring Retainer, Upper
4 Spring Bracket, In Body
5 Control Arm (Lower)
6 Bolt
7 Washer
8 Plate
9 Self-Locking Nut
10 Rear Subframe (Crossmember)
11 Flanged Bolt
12 Eccentric bolt
13 Eccentric Washer
14 Bolt With Washer
15 Self-Locking Nut
16 Shock absorber mount, in body
17 Self-Locking Nut
18 Shock Absorber
19 Self-Locking Nut
20 Track (Upper) Control Arm
21 Tie rod
22 Link
23 Washer
24 Eccentric washer
25 Wheel Bearing Housing (Knuckle)
26 Flanged bolt

WARNING: The flanged bolt must be loosened or tightened only with the vehicle standing on its wheels. Otherwise, there is risk of accident.

27 Drive axle
28 Self-locking nut
29 Clamping sleeve
30 Wheel speed sensor
31 Eccentric bolt
32 Bolt
33 Link rod
34 Stabilizer bar
35 Backing plate
36 Flanged bolt
37 Washer
38 Washer


RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.