Selecting Functions

After establishing the data link, checking the control module version, and pressing the button:





Indicated on display (function selection, example 02 "Check DTC Memory")You can now select one of the functions listen below. Start the troubleshooting procedure using the "Check DTC Memory" function 02.

01- Check Control Module Versions
02- Check DTC Memory
03- Output Diagnostic Test Mode
04- Basic Setting
05- Erase DTC Memory
06- End Output
07- Code Control Module
08- Read Measuring Value Block
09- Read Individual Measuring Value
10- Adaptation
11- Login Procedure

Comprehensive descriptions of how to use the functions "Erase DTC Memory" and "End Output" are found this repair information.
Descriptions of how to use the other functions are found in this repair information.
When a function has been completed, press the (arrow) button to return to the beginning of the troubleshooting procedure ("Select function XX").

Erase DTC Memory
Requirements
^ DTC memory checked

- Press (arrow) button.





Indicated on display
- Press buttons -0- and -5- to select "Erase DTC Memory" function 05.





Indicated on display
- Press the -Q- button to confirm input.





Indicated on display
- Press (arrow) button.





Indicated on display

Notes:





^ If this is displayed, the check sequence has not been carried out.
^ Follow the test sequence exactly, that is first check DTC memory, then erase DTC memory in the same diagnostic cycle.

End Output





Indicated on display
- Press buttons -0- and -6- to select "End Output" function 06.





Indicated on display
- Press the -Q- button to confirm input.





Indicated on display
- Switch ignition off.
- Disconnect scan tool.