Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1998A8 SEDAN (4D2) V8-3.7L (AEW)REPAIR AND DIAGNOSISBODY AND FRAMESEATSSERVICE AND REPAIRFRONT SEATSGUIDE RAIL, REMOVING AND INSTALLING
1998 Audi A8 Sedan (4D2) V8-3.7L (AEW)
Guide Rail, Removing and Installing
1998 Audi A8 Sedan (4D2) V8-3.7L (AEW)SECTION Guide Rail, Removing and Installing
Guide Rail, Removing And Installing
Special tools and equipment
- VAS 1978
Work procedure
- Remove front seat.
- Electrical wiring - 2 - and - 3 - removed from connector - 4 -.
- Disconnect connectors - 1 -.
- Pull out connecting wire - 5 - with VAS1978 from connector housing - 6 -.
- Remove wiring from seat frame.
- Remove bolt - 6 -.
- Tightening torque: 20 Nm (15 ft.lb.)
- Slide guide rail slightly to back (arrow).
- Unhook guide rail from below.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.