Navigation System III, Component Overview

1998 Audi A8 Sedan (4D2) V8-3.7L (AEW)SECTION Navigation System III, Component Overview








1 - Function selection switch II, in center console -E272
- In center console
- Removing and installing.
2 - Display in instrument cluster
- In instrument panel
- Removing and installing
3 - Antenna for Navigation (GPS) -R50
- On trunk lid
- Removing and installing.
4 - Navigation control module with CD drive -J401
- In luggage compartment behind left side trim
- Removing and installing.
5 - Speaker for - telephone/navigation -R39
- In B-pillar trim
- For vehicles without radio system or with radio with BOSE sound system
- Removing and installing.
6 - Mid - range/tweeter
- In front door trim (top)
- Removing and installing Refer to "Speakers, Removing and Installing" Service and Repair
7 - Bass speaker
- In front door trim (bottom)
- Removing and installing.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.