Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1998A4 AVANT QUATTRO, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSSHIFT INTERLOCK SYSTEMSADJUSTMENTSIGNITION INTERLOCK CABLE
1998 Audi A4 Avant Quattro, Automatic
Ignition Interlock Cable
1998 Audi A4 Avant Quattro, AutomaticSECTION Ignition Interlock Cable
- Remove cable housing mounting screws at gear selector console. Loosen lock screw. Move gear selector to "D" position. Turn ignition on. Move control cable until a .060" (1.5 mm) feeler gauge fits between lock flap and lock pin. See Fig 1 .
- Turn ignition off. Turn ignition on. Ensure gap is still .060" (1.5 mm). Turn ignition off and on several times and recheck gap. Install cable housing to gear selector console.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.