Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC 00000: No Fault Detected
If DTC 00000 is displayed from scan tool along with ABS or TCS warning light(s) on, check for ABS control module supply voltage less than 10.5 volts at a speed of less than 4 MPH. See WIRING DIAGRAMS . If no electrical fault is detected, a mechanical fault (such as a stuck solenoid) may be causing warning light to come on. See CIRCUIT TESTS.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.