Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Safety Lockout Switch
Remove safety lockout switch and disconnect harness connector. Check continuity between switch terminals with switch in appropriate position. See SAFETY LOCKOUT SWITCH TEST table. See Fig 1 . If continuity is not as specified, replace safety lockout switch.
| Switch Position | Check Between Terminal No. | Specification | |
|---|---|---|---|
| Off | |||
| 1 & 2 | No Continuity | ||
| 3 & 4 | No Continuity | ||
| On | |||
| 1 & 2 | Continuity | ||
| 3 & 4 | Continuity | ||
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.