Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1996A4 BASE, STANDARDREPAIR AND DIAGNOSISTRANSMISSIONMANUAL TRANSSERVICING - M/T (012/01W)REMOVAL & INSTALLATIONSHIFT MECHANISMINSTALLATION
1996 Audi A4 Base, Standard
Shift Mechanism: Installation
1996 Audi A4 Base, StandardSECTION Installation
NOTE:
Tighten all bolts and nuts to specification. See TORQUE SPECIFICATIONS .
- Install in reverse order of removal, noting the following: Push shift rod on so that securing bolt fits into recess of shift rod.
- Secure shift rod (arrow -A-). See Figure. Secure pivot rod to transmission (arrow -B-).
- Adjust shift linkage. See SHIFT MECHANISM . Install heat shield. Align exhaust system free of stress.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.