Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1996A4 BASE, STANDARDREPAIR AND DIAGNOSISTRANSMISSIONMANUAL TRANSSERVICING - M/T (012/01W)ADJUSTMENTSSHIFT MECHANISMSHIFT MECHANISM (FINE ADJUSTMENT)
1996 Audi A4 Base, Standard
Shift Mechanism (Fine Adjustment)
1996 Audi A4 Base, StandardSECTION Shift Mechanism (Fine Adjustment)
- Loosen nuts for ball housing (arrows A and B). See Fig 1. Move shift lever together with ball housing to right toward 5th/reverse gear gate up to stop in transmission and hold in position. Press ball housing to left against shift lever.
- Hold shift lever and ball housing in position. Tighten ball housing nut (A) to 18 ft. lbs. (25 N.m). Tighten ball housing nut (B) to 84 INCH lbs. (10 N.m). Install covers and shift knob.NOTE: If only 5th gear and reverse gear cannot be engaged, the 5th and reverse gear lock must be checked and replaced if necessary. See REMOVING & INSTALLING (GEAR LOCK FOR FIFTH & REVERSE GEAR) .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.