Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1996A4 BASE, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROLS - TESTS W/O CODESSYMPTOMSWILL NOT START (CRANKS OKAY)NO SPARK
1996 Audi A4 Base, Standard
No Spark
1996 Audi A4 Base, StandardSECTION No Spark
- Ensure secondary ignition system is in good condition.
- Ensure ignition coil supply voltage is correct.
- Ensure ignition coil primary resistance is correct.
- Ensure ignition coil secondary resistance is correct.
- Check camshaft position sensor operation.
- Ensure PCM has correct voltage supply and is properly grounded.
- Check vehicle for aftermarket electronic equipment that may have been installed incorrectly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.