Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1996A4 BASE, STANDARDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEMDIAGNOSIS & TESTINGFINAL CHECK
1996 Audi A4 Base, Standard
Final Check
1996 Audi A4 Base, StandardSECTION Final Check
- Remove test equipment, and prepare ABS system for normal operation. Start engine, and observe ANTI-LOCK light in vehicle. Light should go out. While engine is running, actuate switch for ABS system. Indicator light must illuminate.
- Turn ignition off, and restart engine. Indicator light must go out. Drive vehicle faster than 20 MPH. ANTI-LOCK light must not come on. If light comes on, repeat entire test sequence.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.