Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1996A4 BASE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONMANUAL TRANSSERVICING - M/T (012/01W)REMOVAL & INSTALLATIONVEHICLE SPEED SENSOR DRIVE WHEELINSTALLATION
1996 Audi A4 Base, Standard
Vehicle Speed Sensor Drive Wheel: Installation
1996 Audi A4 Base, StandardSECTION Installation
- Installation is the reverse order of removal, note the following: Installation position: The drive peg of the drive gear -A- faces seal -B- and locks into groove in the differential. See Figure. The retaining clips (arrows) lock in the circumferential groove in the differential. See Figure. Always replace seal -B- and circlip -C-. See AXLE SEALS . Drive in drive flange using VW295 needle bearing drift.
- Check transmission oil level. Top off to lower edge of fill hole, if necessary. See LUBRICATION . Tighten all bolts and nuts to specification. See TORQUE SPECIFICATIONS .
NOTE:
Carefully install drive gear onto differential without canting. Do not use force: the drive gear can break easily.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.