SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1996A4 BASE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)STEERINGPOWER STEERINGSTEERING SYSTEM - POWERLUBRICATIONFLUID LEVEL CHECK
1996 Audi A4 Base, Standard

Fluid Level Check

1996 Audi A4 Base, StandardSECTION Fluid Level Check
NOTE: DO NOT re-use drained hydraulic fluid.

With front wheels in straight-ahead position, run engine at idle for 2 minutes. Stop engine (switch off ignition) and remove cap with dipstick. When engine is cold, fluid level must be in area of "MIN" marking, up to 0.08" (2 mm) above or below marking. When engine is at operating temperature, fluid level must be between "MIN" and "MAX" markings.

NOTE: If there is too much fluid in reservoir, fluid must be extracted. If there is not enough fluid, it is not sufficient to just top off fluid; hydraulic system must also be checked for leaks.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.