Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transportation blocks for front struts, removing
1996 Audi A4 Base, StandardSECTION Transportation blocks for front struts, removing
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
On some vehicles, transportation blocks are installed in the front struts. These vehicles can be recognized by the presence of a tag on the mirror (arrow).
- Release pressure on coil springs (e.g. by lifting vehicle using vehicle lift). Follow all safety precautions when lifting vehicle. See AVANT AND SEDAN, LIFTING .
NOTE:
It is not necessary to remove the wheels.
- Pull down buffer stop -2-.
- Remove blocks -1- (two blocks in each strut).
- Push buffer stop -2- upward and clip into spring retainer.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.