SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1996A4 BASE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)EXTERNAL PAGESDIFFERENT CARSECTION 94 (MAINTENANCE)DESCRIPTIONS OF OPERATIONSNOISE INSULATION PANEL, REMOVING
1996 Audi A4 Base, Standard

Noise insulation panel, removing

1996 Audi A4 Base, StandardSECTION Noise insulation panel, removing
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
  • Remove quick-release screws -A-.
  • Pull clamping pins -B- out with slight rotation.
  • Pull noise insulation panel rearward from bumper cover and remove.
Fig 1: Removing Quick-Release Screws, Clamping Pins & Noise Insulation Panel
G02722930Courtesy of AUDI OF AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.