Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1996A4 BASE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)EXTERNAL PAGESDIFFERENT CARSECTION 68 (STEERING)SERVOTRONIC, ASSEMBLY OVERVIEWNOTES
1996 Audi A4 Base, Standard
Servotronic, assembly overview: Notes
1996 Audi A4 Base, StandardSECTION Notes
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
The following list pertains to Fig 1.
- Power steering gear with tie rods
- Assembly Overview, see POWER STEERING GEAR, ASSEMBLY OVERVIEW
- Connector for servotronic
- Relay carrier, 13-pin
- Located under trim in driver's footwell
See appropriate System Wiring Diagrams article.
- Relay for servotronic control module - J236- (position 13)
- Checking voltage supply, see SERVOTRONIC, CHECKING VOLTAGE SUPPLY
- Checking speed signal, see SPEED SIGNAL, CHECKING
- Located under trim in driver's footwell
- Socket-head bolt, 3 Nm
- 2.5 mm
NOTE: Do not open Torx bolts! - Servotronic solenoid valve - N119-
- Steering gear must be removed to replace servotronic valve.
- Checking, see SERVOTRONIC VALVE, CHECKING
NOTE: DO NOT open Torx bolts! - Seal
- Always replace
- Seal
- Always replace
- Sieve
- Always replace
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.