Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1996A4 BASE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)EXTERNAL PAGESDIFFERENT CARSECTION 17 (SUSPENSION - REAR, AWD)REMOVAL & INSTALLATIONNOTES
1996 Audi A4 Base, Standard
Removal & Installation: Notes
1996 Audi A4 Base, StandardSECTION Notes
WARNING: This page is about a different car, the 2000 Audi A6, 1999 Audi A6, and 1998 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not use power tools to tighten fasteners. Torque specifications could be exceeded. Always use NEW brake caliper bolts, upper inner and outer control arm bolts, subframe bolts, lower strut assembly bolt, lower inner control arm bolts and all self-locking nuts. Replace any worn or corroded fasteners.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.