Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSAUDI1996A4 BASE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)EXTERNAL PAGESDIFFERENT CARSECTION 15 (2.8L V6)OVERHAULCYLINDER BLOCK ASSEMBLYROD BEARINGS

1996 Audi A4 Base, Standard

Rod Bearings

1996 Audi A4 Base, StandardSECTION Rod Bearings

WARNING: This page is about a different car, the 1996 Audi Cabriolet and 1995 Audi Cabriolet. However, it is still accessible from the selected car via links, so may be relevant.

If using Plastigage to check rod bearing oil clearance, DO NOT fully tighten bearing cap bolts. Instead, tighten bolts to 15 ft. lbs. (20 N.m). If rod bearing oil clearance is not within specification, replace rod bearings. See CRANKSHAFT, MAIN & CONNECTING ROD BEARINGS table under ENGINE SPECIFICATIONS. Replace rod bearing cap bolts after first use. Tighten bolts to proper specification. See TORQUE SPECIFICATIONS .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.