Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P1612/18020 - Pcm Incorrectly Coded
1996 Audi A4 Base, StandardSECTION DTC P1612/18020 - Pcm Incorrectly Coded
- If DTC P1606/18014 is not also set in memory, go to next step. If DTC P1606/18014 is also set in memory, PCM is incorrectly coded. Vehicle is equipped with traction control, but PCM coding was done for a vehicle without traction control. Properly code PCM test drive vehicle. See PCM CODING and TEST DRIVE in this article. Recheck DTC memory and verify DTC does not set again. If DTC sets again, go to next step.
- PCM is incorrectly coded. Vehicle is equipped with an automatic transmission, but PCM coding was done for a vehicle with a manual transmission. Properly code PCM test drive vehicle. See PCM CODING and TEST DRIVE in this article. Recheck DTC memory and verify DTC does not set again.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.