Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1996A4 BASE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEM/TRACTION CONTROLDIAGNOSIS & TESTINGCLEARING DTCS
1996 Audi A4 Base, Standard
CLEARING DTCs
1996 Audi A4 Base, StandardSECTION CLEARING DTCs
NOTE:
DTCs must be output before attempting to clear DTCs. DTCs will not clear if vehicle is driven over 13 MPH (20 km/h) or ignition is turned off between retrieving DTCs and clearing DTCs.
- With scan tool connected and ignition on, access SELECT FUNCTION menu selection screen. Enter 05 to select ERASE DTC MEMORY. Press "Q" key to confirm input.
- Turn ignition off. Disconnect scan tool data cable from DLC. Turn ignition on. Verify ABS (and TCS if equipped) warning light goes out 2-4 seconds after ignition is turned on. Road test vehicle to ensure warning lights do not come on during road test. If ABS, TCS or EDL warning lights come on during test drive, repeat diagnostic procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.