Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC 00646 - Abs Motor Electrical Connection No. 1
1996 Audi A4 Base, StandardSECTION DTC 00646 - Abs Motor Electrical Connection No. 1
NOTE:
DTC 00646 applies only to models with Traction Control System (TCS).
- Fault may be caused by the following;
- Open circuit, short to ground or short to battery voltage in circuits between ABS control module and Engine Control Module (ECM).
- Faulty ECM.
- Faulty ABS control module.
- Check for open or short in circuits between ABS control module and ECM. If no faults can be located in circuits between ECM and ABS control module, substitute a known good ECM and recheck for symptom and DTC.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.