Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1996A4 BASE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESANTI-LOCK BRAKE SYSTEM/TRACTION CONTROLDTC TESTINGDTC 00526 - STOPLIGHT SWITCH
1996 Audi A4 Base, Standard
DTC 00526 - Stoplight Switch
1996 Audi A4 Base, StandardSECTION DTC 00526 - Stoplight Switch
- DTC 00526 indicates ABS control module is not receiving a stoplight switch signal. Fault may be caused by the following;
- Both stoplight bulbs out.
- Open circuit or short to ground in stoplight circuit.
- Faulty stoplight switch
- Faulty ABS control module.
- Ensure stoplight bulbs are okay. Check stoplight switch operation by checking measuring value block display field 05 with VAG 1551. Check stoplight circuit for open or short to ground. See WIRING DIAGRAMS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.