Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI1996A4 BASE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATS - POWERREMOVAL & INSTALLATIONBACKREST ADJUSTMENT MOTOR
1996 Audi A4 Base, Standard
Backrest Adjustment Motor
1996 Audi A4 Base, StandardSECTION Backrest Adjustment Motor
- Remove power seat assembly from vehicle. Remove backrest adjustment motor wiring harness connector. See Fig 1 . Remove seat heater coil drive connector (if equipped). Remove seat trim cover.
- Remove screws from backrest stop. Carefully pry backrest from trim. Pull trim down and off seatback. Straighten upholstery hooks and pull cover foreword. Remove backrest adjustment motor and bracket. To install, reverse removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.