Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI199590 QUATTRO SPORT V6-2.8L (AAH)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSTRANSMISSION AND DRIVETRAINSYSTEM SPECIFICATIONS
1995 Audi 90 Quattro Sport V6-2.8L (AAH)
System Specifications
1995 Audi 90 Quattro Sport V6-2.8L (AAH)SECTION System Specifications
Component Torque/Ft. Lbs.
Axle Shaft To Drive Flange Bolts 35
Axle Nut 236
Axle To Bearing/Subframe Bolts 33
Ball Joint Bracket To Control Arm Nuts 48
Ball Joint Mounting Bolts 29
Ball Joint To Ball Joint Bracket Nut 55
Center Support Bearing To Body Bolts 14
Driveshaft Nut 236
Hub Nut 236
Propeller Shaft To Differential Flange Bolts 40
Propeller Shaft To Transaxle Flange Bolts 40
Rubber Bonded Bushing To Subframe Bolts 18
Strut Assembly Nut 44
Strut To Body Nut 48
Strut To Strut Assembly Housing Nut 132
Tie Rod End To Wheel Bearing Housing Nut 29
Wheel Lug Nuts 81
Axle Shaft To Drive Flange Bolts 35
Axle Nut 236
Axle To Bearing/Subframe Bolts 33
Ball Joint Bracket To Control Arm Nuts 48
Ball Joint Mounting Bolts 29
Ball Joint To Ball Joint Bracket Nut 55
Center Support Bearing To Body Bolts 14
Driveshaft Nut 236
Hub Nut 236
Propeller Shaft To Differential Flange Bolts 40
Propeller Shaft To Transaxle Flange Bolts 40
Rubber Bonded Bushing To Subframe Bolts 18
Strut Assembly Nut 44
Strut To Body Nut 48
Strut To Strut Assembly Housing Nut 132
Tie Rod End To Wheel Bearing Housing Nut 29
Wheel Lug Nuts 81
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.