Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI199590 QUATTRO SPORT V6-2.8L (AAH)REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - RESTRAINTS AND SAFETY SYSTEMSAIR BAG CONTROL MODULESERVICE AND REPAIR
1995 Audi 90 Quattro Sport V6-2.8L (AAH)
Air Bag Control Module: Service and Repair
1995 Audi 90 Quattro Sport V6-2.8L (AAH)SECTION Service and Repair
Fig. 12 Rear Center Console.:
Fig. 13 Front Center Console.:
Fig. 14 Air Bag Control Module Nut Locations.:
1. Disarm air bag system as described under Air Bags (Supplemental Restraint Systems), Service and Repair.
2. Remove ash tray from rear center console, Fig. 12.
3. Remove rear center console mounting screws.
4. Pull rear center console upward to detach from locking lugs.
5. Disconnect electrical connectors, then remove rear center console.
6. Remove knobs from heater control panel, then the trim plate.
7. On vehicles with automatic air conditioning, remove A/C control panel.
8. Remove filler retaining screws and filler.
9. Remove gear shift lever knob.
10. Remove screw attaching gear shift lever boot to front center console, then the boot, Fig. 13.
11. Pull front center console toward rear to disengage from guides.
12. Disconnect front center console electrical connectors, then remove front center console.
13. Remove control module retaining nuts, Fig. 14.
14. Disconnect control module electrical connector, then remove triggering unit.
15. Reverse procedure to install. Tighten control module retaining nuts to specifications.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.