Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI199590 QUATTRO SPORT V6-2.8L (AAH)REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BRAKES AND TRACTION CONTROLELECTRONIC BRAKE CONTROL MODULESERVICE AND REPAIR
1995 Audi 90 Quattro Sport V6-2.8L (AAH)
Electronic Brake Control Module: Service and Repair
1995 Audi 90 Quattro Sport V6-2.8L (AAH)SECTION Service and Repair
The electronic control unit is located beneath the lefthand side of the rear seat.
1. Turn ignition switch to the Off position.
2. Remove rear seat.
3. Remove spring retaining electrical connector, then disconnect electrical connector.
4. Remove screws securing control unit.
5. Reverse procedure to install.
1. Turn ignition switch to the Off position.
2. Remove rear seat.
3. Remove spring retaining electrical connector, then disconnect electrical connector.
4. Remove screws securing control unit.
5. Reverse procedure to install.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.