Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI199590 QUATTRO SPORT V6-2.8L (AAH)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESSCAN TOOL TESTINGWITH MMS 300 ENGINE MANAGEMENT SYSTEMEND OUTPUT (FUNCTION 06)
1995 Audi 90 Quattro Sport V6-2.8L (AAH)
End Output (Function 06)
1995 Audi 90 Quattro Sport V6-2.8L (AAH)SECTION End Output (Function 06)
END OUTPUT
(VAG 1551 function 06)
Ending an output or readout of the On Board Diagnostic system using the VAG 1551 Scan Tool
REQUIREMENTS
- Scan Tool remains connected.
PROCEDURE
Rapid data transfer HELP
Select function XX
- Press 0 and 6 buttons to select function 06 "End output"
- Display will appear as shown:
Rapid data transfer Q
06 - End output
- Press Q button to enter input
- Display will appear as shown:
Rapid data transfer HELP
Input address word XX
(VAG 1551 function 06)
Ending an output or readout of the On Board Diagnostic system using the VAG 1551 Scan Tool
REQUIREMENTS
- Scan Tool remains connected.
PROCEDURE
Rapid data transfer HELP
Select function XX
- Press 0 and 6 buttons to select function 06 "End output"
- Display will appear as shown:
Rapid data transfer Q
06 - End output
- Press Q button to enter input
- Display will appear as shown:
Rapid data transfer HELP
Input address word XX
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.