Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI199590 BASE, 2.8 K, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)SUSPENSIONWHEEL ALIGNMENTWHEEL ALIGNMENT SPECIFICATIONS & PROCEDURESWHEEL ALIGNMENT SPECIFICATIONS
1995 Audi 90 Base, 2.8 K, Automatic
Wheel Alignment Specifications
1995 Audi 90 Base, 2.8 K, AutomaticSECTION Wheel Alignment Specifications
NOTE:
Riding height should vary less than 1" (25.4 mm) between left and right side of vehicle.
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Preferred | Range | ||||||||
|---|---|---|---|---|---|---|---|---|---|---|
| All Wheel Drive | ||||||||||
| Camber (1) | ||||||||||
| Front | -.75 | -1.25 To -.25 | ||||||||
| Rear | -.50 | -.75 To -.25 | ||||||||
| Caster (2) | 2.0 | 1.5 To 2.5 | ||||||||
| Toe-Out (3) | ||||||||||
| Front | .12 (3) | .0 To 23 (0 To 6) | ||||||||
| Rear | .06 (1) | .0 To 16 (0 To 4) | ||||||||
| Toe-Out (1) | ||||||||||
| Front | .24 | .37 To .12 | ||||||||
| Rear | .12 | .0 To 32 | ||||||||
| Front Wheel Drive | ||||||||||
| Camber (1) | ||||||||||
| Front | -.75 | -1.25 To -.25 | ||||||||
| Rear | -1.50 | -1.25 To -1.75 | ||||||||
| Caster (2) | 2.0 | 1.75 To 2.25 | ||||||||
| Toe-Out (3) | ||||||||||
| Front & Rear | .12 (3) | .08 To .16 (2 To 4) | ||||||||
| Toe-Out (1) | ||||||||||
| Front & Rear | .24 | .16 To .32 | ||||||||
|
||||||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.