Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI199590 BASE, 2.8 K, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTSTEERING COLUMN SWITCHESREMOVAL & INSTALLATIONCOMBINATION SWITCH
1995 Audi 90 Base, 2.8 K, Automatic
Combination Switch
1995 Audi 90 Base, 2.8 K, AutomaticSECTION Combination Switch
- Remove horn pad and steering wheel. See procedures under STEERING WHEEL & HORN PAD . Remove telescopic lever. See Figure . Loosen setscrew for tilt wheel lever. Remove upper shroud from steering column. Disconnect electrical connectors from combination switch.
- Insert a 5/32" (4 mm) Allen wrench through hole in bottom of lower shroud, and loosen combination switch clamp screw. Remove combination switch. To install, reverse removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.