1986 Audi Coupe AutomaticFACTORY OEM SERVICE PROCEDURE

Switching Module Test - 5000CS Turbo

  1. Check Blue wire from terminal No. 1 of ignition coil to switching module for any damage or corrosion. Repair if necessary. Using a jumper wire, connect coil tower wire to ground.
  2. Unplug connector from switching module (next to ignition coil). Connect voltmeter between terminal No. 2 (Green/White wire) and ground. See Fig 1. Install a jumper wire between terminal No. 1 and ground.
    NOTE: Ensure test lead connections are correct. If reversed, ignition control unit will be damaged.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.