Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1986 Audi Coupe AutomaticFACTORY OEM SERVICE PROCEDURE
Ignition System - Hall Effect
- Description
- Operation
- Adjustments
- Testing
- Pre-Test Procedures - All Models
- Electronic Ignition Control Unit Test - 4000S
- Hall Control Unit Test - 4000S
- Hall Effect Sending Unit Test - 4000S
- Idle & Full Throttle Switch Test - 4000S
- Ignition Coil Resistance Check - 4000S
- Spark Plug Wires & Rotor - 4000S
- Ignition System Test - 5000CS Turbo
- Ignition System Trouble Shooting - 5000CS Turbo
- Notes
- Fault Indicator Light Is Off
- Tachometer Indicates 1000 RPM Fault Indicator Light Is On
- Tachometer Indicates 2000 RPM Fault Indicator Light Is Off
- Tachometer Indicates 2000 RPM Fault Indicator Light Is On
- Tachometer Indicates 3000 RPM Fault Indicator Light Is Off
- Tachometer Indicates 3000 RPM Fault Indicator Light Is On
- Tachometer Indicates 4000 RPM Fault Indicator Light Is On
- Tachometer Indicates 4000 or 6000 RPM Fault Indicator Light Is Off
- Tachometer Indicates 5000 RPM Fault Indicator Light Is Off
- Tachometer Indicates 7000 RPM Fault Indicator Light Is Off
- Tachometer Indicates 7000 RPM Fault Indicator Light Is On
- Ignition Coil Test - 5000CS Turbo
- Switching Module Test - 5000CS Turbo
- Ignition Timing Reference Sensor Test - 5000CS Turbo
- Rpm Sensor Test - 5000CS Turbo
- Intake Air Temperature Sensor Test - 5000CS Turbo
- Coolant Temperature Sensor Test - 5000CS Turbo
- Idle & Full Throttle Switch Test - 5000CS Turbo
- Hall Effect Sending Unit Test - 5000CS Turbo
- Ignition Control Unit Voltage Supply Test - 5000CS Turbo
- Ignition Control Unit Output Signal Test - 5000CS Turbo
- Overhaul
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
