Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Wiper/Washer Switch Test: Test
How to use this service information .
- SRS components are located in this area. Before doing repairs or service:
NOTICE:Â
When working with a vehicle equipped with the electronic air suspension, be sure to set it to the leveling off mode to prevent unexpected operation. Refer to the Electronic Air Suspension System Service Precautions - Refer to: Electronic Air Suspension System Connector Fitting Precautions or Electronic Air Suspension System Service Precautions for the procedure.
- Wiper/Washer Switch - Test
PreconditionsÂ
Figure 1Â
Windshield (Type A) (Figure 2)Â
Rear window (Type A) (Figure 3)Â
Windshield (Type B) (Figure 4)Â
Rear window (Type B) (Figure 5)Â
Procedure/SpecificationsÂ
- Check the switch according to the table. (Figure 1 and 2)
ResultÂ
- If the result is not as specified, replace the wiper/washer switch.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.