Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Body Control Module Inspection
PreconditionsÂ
This procedure can be done before any other inspections are completed because this test procedure includes all of the following inspection items. However, if this test fails, it will be necessary to continue with each inspection item individually to determine which item failed.
- External circuit is normal
Test ProcedureÂ
- Preparation
-
- Rear interior LF antenna connector (2P): disconnected
- Procedure
-
- Perform the inspection according to the following table.
(Disconnected) Rear interior LF antenna connector (2P) female terminals
IG Mode
Normal Conditions
Module internal circuit inspectionÂ
ON*1
VoltageÂ
*1: If the matter whether the vehicle mode ON or OFF (LOCK) because of the permanent power supply.
ResultsÂ
- If it is abnormal, there is a problem with the body control module.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.