SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2018TLX BASE, 2.4L ENGREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLVSA SYSTEM - DIAGNOSTICS (1 OF 2)VSA DTC ADVANCED DIAGNOSTICSDTC ADVANCED DIAGNOSTICS: VSA RELATED DTCS (2015-17)DTC 142-14: LEFT-FRONT BRAKE CALIPER PRESSURE SENSOR MALFUNCTION
2018 Acura TLX Base, 2.4L Eng

DTC 142-14: Left-Front Brake Caliper Pressure Sensor Malfunction

2018 Acura TLX Base, 2.4L EngSECTION DTC 142-14: Left-Front Brake Caliper Pressure Sensor Malfunction
Confirmation Procedure Basic Condition:
  • 12 volt battery voltage 9.6 - 16.5 V

Operating Condition:

  • 1.

    Start the engine.

  • 2.

    Test-drive the vehicle at 10 mph (15 km/h) or less for at least 30 seconds.

    (Be careful of the surrounding traffic conditions.)
Execution Regular Diagnosis
Duration About 30 seconds
DTC Type
  • 1 drive cycle
  • None
Fail Safe Action
  • Stop ACC/CMBS function (With ACC)
Possible Cause
  • VSA modulator-control unit internal failure
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.