Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Exterior Trim / Windshield Wiper - Service Information (Except Hybrid)
2015 Acura RLXSECTION Exterior Trim / Windshield Wiper - Service Information (Except Hybrid)
- Disassembly and Reassembly
- Removal Installation Test
- Removal and Installation
- Automatic Lighting/Rain Sensor Removal and Installation(With Automatic Wiper) (2014 2015 2016 2017)
- Cowl Cover Removal and Installation
- Emblem/Sticker Removal and Installation (2014 2015 2016 2017)
- Emblem/Sticker Removal and Installation (2018 2019 2020)
- Engine Undercover Removal and Installation
- Front Bumper Air Spoiler Removal and Installation
- Front Bumper Center Lower Grille Removal and Installation (2014 2015 2016 2017)
- Front Bumper Removal and Installation (2014 2015 2016 2017)
- Front Bumper Removal and Installation (2018 2019 2020)
- Front Bumper Removal and Installation(With Multi View Camera System) (2016 2017)
- Front Bumper Side Trim Removal and Installation (2014 2015 2016 2017)
- Front Fender Fairing Removal and Installation
- Front Fender Trim Removal and Installation
- Front Floor Undercover Removal and Installation
- Front Grille Cover Removal and Installation (2014 2015 2016 2017)
- Front Grille Cover Removal and Installation (2018 2019 2020)
- Front Grille Removal and Installation (2014 2015 2016 2017)
- Front Grille Removal and Installation (2018 2019 2020)
- Front Inner Fender Removal and Installation(KA/KX model)
- Front Upper Trim Removal and Installation (2018 2019 2020)
- Fuel Cap Adapter Removal and Installation
- Fuel Fill Door Opener Solenoid Removal and Installation
- Fuel Fill Door Opener Switch Removal and Installation
- Headlight Washer Nozzle Removal and Installation
- Headlight Washer Switch Removal and Installation
- Hood Insulator Removal and Installation
- Hood Latch Removal and Installation
- Hood Opener Cable Removal and Installation
- Hood Release Handle Removal and Installation
- Hood Seal Removal and Installation
- Hood Support Strut Removal and Installation
- MFI Protection Cover Removal and Installation
- Middle Floor Undercover Removal and Installation
- Rear Air Outlet Removal and Installation
- Rear Bumper Removal and Installation
- Rear Floor Undercover Removal and Installation
- Rear Inner Fender Removal and Installation
- Rear License Trim Removal and Installation
- Roof Molding Removal and Installation
- Side Sill Panel Removal and Installation (2014 2015 2016 2017)
- Side Sill Panel Removal and Installation (2018 2019 2020)
- Side Sill Protection Tape Removal and Installation (2018 2019 2020)
- Trunk Lid Coil Spring Removal and Installation
- Trunk Lid Cushion Removal and Installation
- Trunk Lid Dynamic Damper Removal and Installation
- Trunk Lid Inside Lever Removal and Installation
- Trunk Lid Latch Removal and Installation
- Trunk Lid Opener Cable Removal and Installation
- Trunk Lid Opener Switch Removal and Installation
- Trunk Lid Outer Handle Switch Removal and Installation
- Trunk Lid Support Strut Removal and Installation
- Trunk Lid Weatherstrip Removal and Installation
- Washer Motor Removal and Installation
- Washer Reservoir Removal and Installation
- Washer Tube Removal and Installation
- Windshield Wiper Control Unit/Motor Removal and Installation
- Wiper Arm Removal and Installation
- Wiper Blade Removal and Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.