SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2015RLXREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESVSA SYSTEM - ADVANCED DIAGNOSTICS (EXCEPT HYBRID)ADVANCED DIAGNOSTICSDTC : VSA RELATED DTCSDTC 16-11: RIGHT-REAR WHEEL SPEED SENSOR ELECTRICAL NOISE OR INTERMITTENT INTERRUPTION
2015 Acura RLX

DTC 16-11: Right-Rear Wheel Speed Sensor Electrical Noise or Intermittent Interruption

2015 Acura RLXSECTION DTC 16-11: Right-Rear Wheel Speed Sensor Electrical Noise or Intermittent Interruption
Confirmation Procedure Basic Condition:
  • Battery voltage 9.6 - 16.5 V

Operating Condition:

  • 1. Start the engine.
  • 2. Wait more than 80 seconds.
Execution Regular Diagnosis
Duration About 80 seconds
DTC Type
  • 1 drive cycle
  • ABS indicator on
  • VSA indicator on
  • Brake system indicator (amber) on
  • Brake system indicator (red) on (If multiple wheel failures are detected)
Fail Safe Action
  • Stop ABS function
  • Stop VSA function
  • Stop EBD function (If multiple wheel failures are detected)
  • Stop TCS function
  • Stop hill start assist function
  • Stop brake assist function
  • Stop hydraulic brake booster function
  • Stop agile handling assist function
  • Stop ACC function
  • Stop CMBS function
Possible Cause
  • Electrical noise in the right-rear wheel speed sensor signal
  • Right-rear wheel speed sensor incorrect installation
  • Debris on the right-rear hub bearing unit (magnetic encoder) surface
  • Right-rear wheel speed sensor failure
  • VSA modulator-control unit internal failure
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.