Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC B2A10-14
DTC B2A10-14 : Brake Light Drive Relay Circuit Malfunction
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| B2A10-14 Brake Light Drive Relay Circuit Malfunction |
DTC (IDAS)
- VSA system DTCs check
-1. Turn the vehicle to the ON mode.
-2. Check for VSA system DTCs with the HDS.
DTC Description DTC Freeze Frame Are any DTCs indicated?
YES
Go to the indicated DTC's troubleshooting .
NO
Go to step 2.
- Problem verification
-1. Clear the DTC with the HDS.
-2. Turn the vehicle to the OFF (LOCK) mode, then the ON mode.
-3. Select Integrated Driver Support System from the DRIVING SUPPORT menu, then enter Brake Light from the FUNCTION TEST menu.
-4. Do the brake light relay function test with the HDS.
Brake Light Relay
Check for DTCs with the HDS.
DTC Description DTC Freeze Frame B2A10-14 Brake Light Drive Relay Circuit Malfunction Is DTC B2A10-14 indicated?
YES
The failure is duplicated. Go to step 3.
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.
- Multipurpose camera unit check (update)
-1. Update the multipurpose camera unit if it does not have the latest software .
-2. Turn the vehicle to the OFF (LOCK) mode, then the ON mode.
-3. Select Integrated Driver Support System from the DRIVING SUPPORT menu, then enter ACC RELAY from the FUNCTION TEST menu.
-4. Do the brake light relay function test with the HDS.
Brake Light Relay
Check for DTCs with the HDS.
DTC Description DTC Freeze Frame B2A10-14 Brake Light Drive Relay Circuit Malfunction Is DTC B2A10-14 indicated?
YES
Check for loose terminals in the multipurpose camera unit 20P connector. If the multipurpose camera unit was updated and the symptom/indication is still present, replace the multipurpose camera unit .
NO
Troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTC's troubleshooting.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.