Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Shift Solenoid Valve C Removal and Installation (2013-18): Installation
2015 Acura RDX AWDSECTION Installation
- Shift Solenoid Valve C - Install
1. Install shift solenoid valve C using new O-rings (A). 2. Connect the shift solenoid valve C connector (A).NOTE: Check the connector for corrosion, dirt, or oil, and clean or repair if necessary. 3. Install the harness clamp (A). - Engine Undercover - Install
1. Install the engine undercover - Refer to: Engine Undercover Removal and Installation (2013-15), or Engine Undercover Removal and Installation (2016-18) .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.