Tire Pressure Monitoring System (TPMS) DTCS

2015 Acura RDX AWDSECTION Tire Pressure Monitoring System (TPMS) DTCS
TIRE PRESSURE MONITORING SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) INDENTIFICATION

DTC Description
C1800-87 Tire Pressure Sensor Signal Reception Error (2013-15)
C1800-87 Tire Pressure Sensor Signal Reception Error (2016-18)
C1801-55 Tire Pressure Sensor ID Registration Error (2013-15)
C1801-55 Tire Pressure Sensor ID Registration Error (2016-18)
C1801-87 Tire Pressure Sensor Signal Transmission Error (2013-15)
C1801-87 Tire Pressure Sensor Signal Transmission Error (2016-18)
C1801-92 Tire Pressure Sensor Low Battery (2013-15)
C1801-92 Tire Pressure Sensor Low Battery (2016-18)
C1801-96 Tire Pressure Sensor Malfunction (2013-15)
C1801-96 Tire Pressure Sensor Malfunction (2016-18)
C1801-98 Tire Abnormally High Temperature (2013-15)
C1801-98 Tire Abnormally High Temperature (2016-18)
C1810-11 Initiator Circuit Short (2013-15)
C1810-11 Initiator Circuit Short (2016-18)
C1811-13 Initiator Circuit Open (2013-15)
C1811-13 Initiator Circuit Open (2016-18)
C1821-78 Tire Low Air Pressure (2013-15)
C1821-78 Tire Low Air Pressure (2016-18)
C1830-00 Vehicle Speed Signal Malfunction (2013-15)
C1830-00 Vehicle Speed Signal Malfunction (2016-18)
U0029-00 F-CAN Malfunction (Bus Off) (2016-18)
U0029-00 F-CAN Malfunction (2013-15)
U0100-00 F-CAN Malfunction (2016-18)
U3000-49 TPMS Control Unit Internal Circuit Malfunction (2013-15)
U3000-49 TPMS Control Unit Internal Circuit Malfunction (2016-18)
U3000-51 TPMS Control Unit Programming Error (2013-18)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.